What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 26.06.2025 02:47

What does a fuse do?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The other is “what does a “fuse” do?”
Will India ever surpass China in Technology?
He then describes the function of a fuse.
But it can get overloaded, and no longer works.
He then describes Rainy Season and Lightning.
I post the exact comment here.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
A fuse is a non-resetable over current circuit protector.
One
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
NASA discovers that Earth's twin planet, Venus, is not geologically dead - Earth.com
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is where this question deviates from being a 'generic' question, and becomes more specific.
the problem then depends on "how fast does the fuse operate?".
Barnstars:
nine
Padres Designate Jason Heyward For Assignment - MLB Trade Rumors
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
(Dc diagram shown, AC is similar).
2024–10–16 [ OO OLAOYE OYEBODE ]
What Happens to Your Blood Pressure When You Drink Energy Drinks Every Day? - Verywell Health
There are two important concepts here.
So, the voltage could go up to 500 volts, and the fuse will not open up.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
The European Central Bank is almost guaranteed to cut rates. Here's what could happen next - CNBC
The bolt then partially travels down the line to your home.
There are three different concepts here that are getting confused.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Elon Musk Says XAI Will Retrain Grok: 'Far Too Much Garbage' - Business Insider
These are simplified answers to the original question, and does not change anything I wrote above.
It seems Mohan does not understand the difference between a comment and an Answer.
but I think this circuit , shows a few more pieces.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
An AC voltage/ current source, and an ac inductive load.
[image of Common-mode choke]
The third is lightning and “how it gets conducted into a home.”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
One is “what exactly is in a ‘surge protector’ ? ”
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Now when you have a certain ac resistance, then a current flows in a loop.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–14 [Omar Gharbi Omar Gharbi ]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Here is a simplified AC power diagram.
a photo is worth a thousand words.
First Sentence:
In schematic diagrams this is the symbol for a fuse:
eight
But… the neutral is now “floating” because of the 1 ohm resistance.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
The MOV will conduct when the voltage exceeds 50% of line voltage.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
but this device (an Inductor) … impedes the rapid changes in the current.
so, what happens?
It also is a device that limits the change in current flow.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
what exactly is a ‘surge’ protector?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
What is lightning?
This is 'the assistant's answer'
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Because the load is inductive, the current lags the voltage.(by a bit).
For this case there are devices called Metal oxide varistors (MOV).
At least they know the answer if they wanted it.
This one hit behind the barn.
At one ohm, the resistor has a maximum of 1 watt power.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
[old diagram got deleted by accident]
Edit 2024–10.
This device then solves the entire problem.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
These devices are installed between the “hot” and “neutral” and protective ground.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–10–10[John johnson John Johnson ]
This is where the MOV conducts again, and dissipated the energy.
He then asserts :
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Upvotes:
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
A circuit breaker is similar, but is resettable.